Adding Incoming Ip Filtering Rules - ZyXEL Communications P-663HN-51 User Manual

Chapter 8 Security
Table 30 Advanced Setup > Security > IP Filtering > Incoming
LABEL
Add
Remove

8.4 Adding Incoming IP Filtering Rules

To add an incoming IP filtering rule, click Advanced Setup > Security > IP
Filtering > Incoming > Add. The screen appears as shown.
Figure 45 Advanced Setup > Security > IP Filtering > Incoming > Add
The following table describes the labels in this menu.
Table 31 Advanced Setup > Security > IP Filtering > Incoming > Add
LABEL
Filter Name
Protocol
Source IP
Address
Source
Subnet Mask
Source Port
96
DESCRIPTION
Click this button to go to a screen where you can configure settings for a
new entry.
To remove a WAN connection, select its Remove check box and click the
Remove button.
DESCRIPTION
Type the name configured to identify the filter entry.
Select the type of packets to which this entry applies (TCP, UDP, or
both).
Type the IP address of a computer on the Internet to which this entry
applies.
Type the subnet mask of a computer on the Internet to which this entry
applies.
Type the source port for traffic (from the Internet) to which this entry
applies.
P-663HN-51 User's Guide