Snmp Screen - ZyXEL Communications P-663HN-51 User Manual

22.2 SNMP Screen

To open this screen, click Advanced Application, Access Control, SNMP.
Figure 94 SNMP
The following table describes the labels in this screen.
Table 66 SNMP
LABEL
SNMP Agent
Read Community
Set Community
System Name
System Location
System Contact
Trap Manager IP
Save/Apply
Port
P-663HN-51 User's Guide
DESCRIPTION
Enable the SNMP agent to turn on SNMP on the ZyXEL Device.
Enter the get community, which is the password for the incoming
Get- and GetNext- requests from the management station.
Enter the set community, which is the password for incoming Set-
requests from the management station.
Specify the name the ZyXEL Device uses for SNMP.
Specify where the ZyXEL Device is.
Specify the name of the person administering the ZyXEL Device.
Enter the IP address of a station to send your SNMP traps to.
The ZyXEL Device sends a coldStart trap when the power is turned
on.
Click this button to save the changes and have the ZyXEL Device start
using them.
Enter the port number upon which the station listens for SNMP traps.
Chapter 22 SNMP
187