Toner And Manual Feed Area Cleaning - Xante FilmMaker 4 Maintenance And Specifications

Fig. 6.2 Transfer Roller
4. Clean toner from the transfer roller with a soft bristle brush.
5. Vacuum the area using a soft brush attachment or blow it with compressed air.
Wear protective safety glasses when using compressed air.
Do not pull out wires while performing this step.
6. Lower the roller back into place with the gear end to the left. Make sure the
lever protruding below the transfer roller fits inside the small opening on the
door.
7. Push the roller into its holding clips. The roller assembly should spring back
freely when pressed.

Toner and Manual Feed Area Cleaning

Clean the toner and manual feed area after removing a paper jam or replacing the
toner cartridge.
1. Turn off the printer and disconnect it from the power source; then remove the
paper jam or the toner cartridge.
Maintenance and Specifications 6-5