Zipper Sewing; To Snap On The Zipper Foot; Fabric Preparation; Oto Sew - Kenmore 385.18330 Owner's Manual

The quilting will help to keep the stitching lines straight.
[] Loosen the quilter holding screw..
Slide the quilter in the hote to the desired width and
tighten the screw.
[] Sew, guiding the quilter over the previous row of stitching.
(_ Quilter holding screw
(_) Quilt_
(_ Hole
® Distance
Zipper Sewing
(_ Stitch selector: 6 to 8
(_ Stitch width: 6.5
_) Stitch length: 2
Needle thread tension: 2 to 6
(_) Presser foot E: Zipper foot
• To Snap on the Zipper Foot
Fit the pin on the zipper foot into the groove on the foot holder.
• To sew the left side of the zipper, attach the zipper foot on
the right-hand side.
• To sew the right side of the zipper, attach the zipper foot on
the left-hand side.
(_) Groove (_) When the left side is sewn
(_) Pin (_ When the right side is sewn
• Fabric preparation
Q Right side of fabric
_) End of opening
(_ Top edge of fabric
(_) 3/4" (2.0cm)
Place right sides, top side of fabric, together and sew to the
end of the zipper opening.
Reverse stitch to lock the stitches, increase stitch length to 4
and set needle thread tension at 0. Sew the zipper opening
with the basting stitch.
"TO
sew
(_) Zipper teeth
(_) Zipper tape
(_) Wrong side (Bottom side) of fabric
[] Fold back the left seam allowance,, Turn under the right
seam allowance to form a 1/8" (0..2 to 0.,3 cm) fold.
Place the zipper teeth O next to this fold and pin in place.
42
[]
[]
r_
I t I0 _WIDT, Q
t I I
,[= I I
® ®
®
®
®
k..
f
[]
J