Kenmore 385.18330 Owner's Manual page 96

Automatic Buttonhole (Continued)
(_ Guide slot
(_ Guide block
(_ Buttonhole guide plate
(_ Buttonhole template
(_) Catch
® Setting mark
Q Gear
(_ Base plate
After you select a template (_ with the style and size of but-
tonhole, slide the template into the guide plate (_. Pull the
catch Q toward you while sliding the template Q until the
selected buttonhole is at the setting mark (_. Insert the gear
of base plate 0 into the guide slot of template 0 and fit the
guide block (_ into the center of the guide slot.
®
-®
®
0 Needle thread
(_ Bobbin thread
(_ Buttonhole foot
(_ Gear
(_ Slot
® Starting point
Attach the buttonhole foot 0, Adjust the position of gear (_
so it is aligned with the starting point of the template O, The
lever can be used to change gear positions Pull the bobbin
thread up through the guide slot of the buttonhole guide plate
by turning the handwheel counterclockwise while holding the
needle thread,, Place the bobbin and needle threads to the
left side of the guide plate, Leave 30" to 40" (7.0 to 100
cm) of thread°
88