Xerox PHASER 5400 Advanced Features And Troubleshooting Manual page 105

Error Description and corrective action
Flash Full The capacity has been exceeded when loading fonts or macros to the
optional flash memory DIMM.
Flushing... Tells you that the PostScript print job could not be printed and is being
<Job Name> parsed out and discarded. This message remains on the display until the job
being flushed is complete, which may require additional data to be sent from
the host. This may require correcting and resubmitting the job to the printer.
Format Failed A problem occurred during disk formatting. Printing may continue, but use
Disk Locked of the disk is locked out.


Fuser Failure The Fuser has failed; printing cannot resume.
Power Off/On








Init Failed This disk cannot be initialized, because it has been locked via a PJL or SNMP
Disk Locked command or through CentreWare Internet Services. (It may be necessary to
re-initialize without the lock.)
Initializing... This message appears for a few seconds while the printer is initializing after
being powered ON.


Initializing... The printer is initializing the flash memory.
Flash Memory


Insert MBF The printer cannot feed from the Multi-sheet Bypass Feeder, because it is not
set normally or is not in position.


Insert Tray 1 The printer cannot feed from Tray 1.


Insert Tray 2 The printer cannot feed from Tray 2.


Insert Tray 3 The printer cannot feed from Tray 3.


Install The Laser Print Cartridge is missing or is not installed correctly.
Print Cartridge




IOT NVM Fail Nonvolatile Memory (NVM) has failed on the print engine, also called the
Power Off/On Image Output Terminal (IOT). Printing cannot resume.




Laser Failure The laser assembly has failed and printing cannot continue.
Power Off/On




Advanced Features and Troubleshooting Manual
Try unlocking the disk (via a PJL or SNMP command or through
CentreWare Internet Services) and reformatting the disk again or replace it.
Power OFF and Power ON the printer.
If the problem occurs again and you have just replaced the Fuser Cartridge,
reseat it.
If the problem occurs again and you have not replaced the maintenance kit,
it may be time to do so.
If the problem persists, contact your Customer Support Center.
Wait.
Wait.
Insert the Multi-sheet Bypass Feeder to resume printing.
Make sure Tray 1 is properly inserted in the printer.
Make sure Tray 2 is properly inserted in the printer.
Make sure Tray 3 is properly inserted in the printer.
Re-install the existing laser print cartridge or install a new one.
If the problem persists, contact your Customer Support Center.
Power OFF and ON the printer.
If this message reappears, contact your Customer Support Center.
Power OFF and ON the printer.
If this message reappears, contact your Customer Support Center.
Control Panel Messages
89