Removing The Battery Latch Assembly - Dell Vostro 1710 Service Manual

Back to Contents Page
Battery Latch Assembly
Dell™ Vostro™ 1710
Service Manual
Removing the Battery Latch Assembly
Replacing the Battery Latch Assembly
Removing the Battery Latch Assembly
CAUTION: Before you begin the following procedure, follow the safety instructions that shipped with your computer.
1. Follow the instructions in Before Working on Your
2. Remove the hard drive (see
3. Remove the WLAN card (see
4. Remove the fan (see Removing the
5. Remove the hinge cover (see
6. Remove the keyboard (see
7. Remove the display assembly (see
8. Remove the palm rest (see
9. Disconnect the cable that secures the internal card with Bluetooth® wireless technology to the system board (see
10. Remove the optical drive (see
11. Remove the system board (see
12. Remove the M2 x 3-mm screw from the battery release button.
13. Push the alignment bracket to the left to remove and lift the battery latch assembly over the pin.
NOTICE: The battery-latch assembly spring is not secured to the latch assembly and can be easily misplaced. When removing the battery latch
assembly, place the spring in a secure location until the latch is ready to be reinstalled.
14. Lift the battery latch assembly out of the computer and unhook the battery latch assembly spring.
NOTICE: Before you remove the battery release button, observe the orientation of the button to ensure proper installation when the button is
replaced.
1 battery latch assembly 2 battery release button
Computer.
Removing the Hard Drive).
Removing a WLAN Card).
Fan).
Removing the Hinge Cover).
Removing the Keyboard).
Removing the Display Assembly).
Removing the Palm Rest).
Removing the Optical Drive).
Removing the System Board Assembly).
Removing the Card).