Displaying The Area Marker Or Aspect Marker - Sony BVME170A Operation Manual

CAPTURE
Save: ENTER Cancel: MENU
To hide characters on the monitor, set the CHAR OFF
button to on. As the characters are hidden, it becomes
easy to confirm the still picture. To display the
characters, set the CHAR OFF button to off.
3
Press the ENTER (Ent) button.
The display of the captured still picture is cleared and
saving in the "Memory Stick" of the captured frame
starts.
The "In progress " is displayed and "
x
during data saving. (It may take some time to write the
data.)
The file of the captured frame is automatically named
and the file name is displayed on the screen during file
saving.
Note
The monitor is not operated until the saving is
completed.
To load the captured frame
Press the Capture Load button
Load in the Capture menu (page 74) of the Function Setting
menu, and then the file name.
To cancel the captured frame display, select any one of
channel numbers 1 to 30.
1) Capture Load is assigned to a function button of the controller in the
Function Key menu (page 92) of the Controller menu.
" flashes
x
1)
of the controller or select
Displaying the Area
Marker or Aspect Marker
The monitor is equipped with two area markers and center
marker as the safe area marker and aspect marker for
confirming the picture angle.
1
Input the signal.
2
Select the channel.
3
Set the marker preset data (Marker1 to Marker5) to
display in the Marker Preset menu (page 64) of the
Channel Configuration menu.
4
Set the marker to display in the Marker Setting menu
(page 69) of the Function Setting menu for the preset
data set in step 3.
5
Select the marker mode (Marker, Aspect Marker, Area
Marker 1, Area Marker 2, Center Marker, Aspect
Marker-Line, Aspect Blanking-Half or Aspect
Blanking-Black) with the function button
controller or in the Function Switch menu (page 75) of
the Function Setting menu and set it to On.
1) Each function of the marker is assigned to the function button of the
controller in the Function Key menu (page 92) of the Controller
menu.
When the MARKER button is set to on
All the markers that are set to On in the Marker Setting
menu of the Function Setting menu are displayed.
The MARKER button lights.
To display the aspect marker
Set the button of the marker mode that you wish to
display (Aspect Marker, Aspect Marker-Line, Aspect
Blanking-Half or Aspect Blanking-Black) to on.
The MARKER, Aspect Marker and the pressed button
light.
To display the area marker 1, area maker 2 or
center marker
Set the button of the maker that you wish to display
(Area Marker 1, Area Marker 2 or Center Marker) to
on.
The MARKER and the pressed button light.
To cancel the marker display
Set the MARKER button to off.
Note
Use the controller with software version 1.6 or higher
to assign Center Marker, Aspect Marker-Line, Aspect

Displaying the Area Marker or Aspect Marker

1)
of the
103