Sony BVME170A Operation Manual page 118

4) The BVM-E170A individual chromaticity points.
The widest color space setting of the signal
reproduced by the BVM-E170A
5) For displaying the color gamut of the wide color
space mode S-GAMUT, which is available for the
F23 or F35 Digital Cinematography Camera
Warm-up time Approx. 30 minutes
Input
SDI BNC (×2)
Input impedance: 75 ohms unbalanced
Signal format
Sampling frequency
3G-SDI:
HD-SDI:
SD-SDI:
Quantization
3G-SDI: 10 bit/sample, 12 bit/sample
HD-SDI: 10 bit/sample
SD-SDI: 10 bit/sample
HDMI HDMI (×1)
Signal format
DisplayPort DisplayPort connector (×1)
Signal format
Option port Four (4) ports
Signal format
Parallel remote D-sub 9-pin (female) (×1)
118
Specifications (BVM-E170A)
x
R 0.681
G 0.189
B 0.141
See "Available Signal Systems"
(page 122) and "Available Signal
Formats" (page 124).
Y/Cb/Cr (4:2:2)
148.5MHz/74.25MHz/74.25MHz
Y/Cb/Cr (4:4:4)
148.5MHz/148.5MHz/148.5MHz
G/B/R (4:4:4)
148.5MHz/148.5MHz/148.5MHz
Y/Cb/Cr (4:2:2)
74.25MHz/37.125MHz/37.125MHz
Y/Cb/Cr (4:2:2)
13.5MHz/6.75MHz/6.75MHz
HDCP correspondence, Deep Color
correspondence
See "HDMI/DisplayPort" (page 130)
of "Available Signal Formats".
HDCP correspondence, 18/24/30bpp
(bits per pixel) correspondence
See "HDMI/DisplayPort" (page 130)
of "Available Signal Formats".
See "Available Signal Systems"
(page 122) and "Available Signal
Formats" (page 124).
Serial remote (LAN)
y
0.319
Output
0.724
SDI
0.051
(Typical)
DC 5V OUT
General
Power requirements
Power consumption
Inrush current
Operating temperature
Operating humidity
Storage/transport temperature
Storage/transport humidity
Ethernet (10BASE-T/100BASE-TX),
RJ-45 (×1)
BNC (×1) (monitor output)
Output signal amplitude:
800 mVp-p±10%
Output impedance: 75 ohms unbalanced
Transmission distance
6)
3G-SDI: 70 m max.
6)
HD-SDI: 100 m max.
7)
SD-SDI: 200 m max.
Note
The signal from the monitor output
connector does not satisfy the ON-LINE
signal specifications.
6) When using the 5C-FB coaxial cable made by
Fujikura Ltd. or equivalent
7) When using the 5C-2V coaxial cable made by
Fujikura Ltd. or equivalent
Circle 4-pin (female) (×1)
100 V to 240 V AC,
1.2 A to 0.7 A, 50/60 Hz
24 V to 28 V DC,
4.5 A to 3.9 A
Approx. 110 W (AC power supply)/
approx. 100 W (DC power supply)
(maximum)
Approx. 60 W (AC power supply)/
approx. 60 W (DC power supply)
(average power consumption in the
default status)
(1) Maximum possible inrush current at
initial switch-on (Voltage changes
caused by manual switching):
55 A peak, 15 A r.m.s. (240V AC)
(2) Inrush current after a mains
interruption of five seconds (Voltage
changes caused at zero-crossing):
36 A peak, 7 A r.m.s. (240V AC)
0 °C to 35 °C (32 °F to 95 °F)
Recommended: 20 °C to 30 °C (68 °F to
86 °F)
0% to 90% (no condensation)
–20 °C to +60 °C (–4 °F to +140 °F)
0% to 90%