Table of Contents
Advertisement
Menu
Restore Factory Data
Position Adj
H Shift
V Shift
Function and operation ([
Resets the color temperature to the default setting.
You cannot select this when the setting is the default value.
The following message appears to confirm the data reset operation.
Restore factory data?
OK: To reset the data, press the ENTER (Ent) button.
Cancel: To cancel, press the MENU button.
Adjusts the position of the picture when the analog signal is input.
When the item is selected, the signal system to be set is displayed.
You can select the item when the composite or Y/C signal from the BKM-227W, or the analog
component or analog component RGB signal from the BKM-229X is displayed.
To hide the characters on the monitor during adjustment
Set the CHAR OFF button of the controller to on. As the characters on the display are
hidden, it becomes easy to adjust the picture. To display the characters, set the CHAR OFF
button to off.
Note
This menu is not selectable when the internal signal or captured frame is displayed.
Adjusts the horizontal position of the picture.
As the setting increases, the picture moves to the right, and as the setting decreases, the
picture moves to the left. [000]
Set in the H Shift Offset menu (page 64) of the Channel Configuration menu when the
difference of the horizontal position is necessary to adjust for different input signals of the
same signal system, etc.
Adjusts the vertical position of the picture.
As the setting increases, the picture moves up, and as the setting decreases, the picture
moves down. [000]
]: factory setting)
57
Adjustment Menu
Advertisement
Table of Contents
