Table of Contents
Advertisement
DISTANCE/SET:
This mode displays
the distance
you have traveled.
This mode also allows distance
goals to be set. To set a distance goal, first select the DISTANCE/SET
mode.
(Make sure the SCAN
mode is notselected.)
Press the SET buttonsto
set the distance youplan
to travel.
Each time one of
the buttons is pressed, the distance displayed will change by 0.2 miles.
The buttons can be held down
to set a distance goal quickly. _As you exercise,
the distance will be counted down.
When the distance
goal is completed,
a tone will sound.
The console will then display the distance you have traveled
since the goal was completed.
Note:
Distance goals can be set only when the base console is in the
manual mode.
SPEED: This mode displays the speed of the walking belt. Note: Each time one of the SPEED but-
tons is pressed, this mode will be displayed automatically for approximately 5 seconds.
CALORIES:
This mode displays
the total number of Calories
you have burned.
For accuracy,
first
select the WEIGHT
SET mode and enter your weight into the base console.
PULSE:
This mode displays your heart rate.
Plug the pulse earclip into the jack on the base console,
and attach the earclip to your left ear lobe. Slide the clothes clip onto your collar to prevent excessive
movement of the earclip wire. After a few seconds, your heart rate will be displayed.
Note: If your
heart rate is not displayed, rub your ear lobe lightly and reposition the earclip.
SCAN:
This mode automatically
displays all modes except WEIGHT
SET, for approximately
3 seconds
each, in a repeating cycle.
Note: The PULSE
mode will be displayed
only if the pulse earclip is worn.
TURNING
OFF THE POWER
Stand on the foot rails of the treadmill.
Remove the safety key from the base console.
kWARNING:
Always
r emove
the safety key from the base console
when you finish
exercising.
TROUBLE-SHOOTING
AND STORAGE
10
Most treadmill
problems
can be solved
by following
the simple
steps
below.
If further assistance
is needed, please call our Customer
Service Department
toll-free at 1-800-999-3756,
Monday through
Friday, 6 a.m. until 6 p.m. Mountain Time (excluding holidays).
1. SYMPTOM:
THE POWER
DOES
NOT TURN ON
a. Make sure the power cord is plugged
into a properly
grounded
outlet.
(See OPERATION
AND
ADJUSTMENT
in this manual.)
If an extension
cord is necessary,
use oniy a 14-gauge
generai_
purpose
cord of approximately
five feet in length.
b. After the power
cord has been plugged
in, make sure the safety key is fully inserted
into the base
console.
Various
indicators
on the base console
should
light.
(See OPERATION
AND ADJUST-
MENT in this manual.)
C°
Check the circuit breaker located on the front of the
frame near the power cord.
The circuit
breaker
is
designed
to protect
the electrical
system.
If the circuit
breaker
has tripped,
the switch will protrude
as shown.
To reset the circuit breaker, allow the treadmill
to cool
for five minutes,
and push the switch back in.
Tripped
Reset
Hide quick links:
Advertisement
Table of Contents
