Table of Contents
Advertisement
Quick Links
Model No. 831.297140
Serial No.
The serial number is found in the location
shown below. Write the serial number in
the space above for future reference.
Serial Number
Decal
CAUTION
Read all precautions and instruc-
tions in this manual before using
this equipment. Save this manual
for future reference.
USER'S MANUAL
Advertisement
Table of Contents
Related Manuals for LIFESTYLER 831.297140
Summary of Contents for LIFESTYLER 831.297140
- Page 1 Model No. 831.297140 Serial No. The serial number is found in the location shown below. Write the serial number in the space above for future reference. Serial Number Decal CAUTION Read all precautions and instruc- tions in this manual before using this equipment.
-
Page 2: Table Of Contents
HOW TO FOLD AND MOVE THE TREADMILL ........ - Page 3 SAVE THESE INSTRUCTIONS The decal shown below has been placed on your treadmill. If the decal is missing, or if it is not legible, please call our toll-free HELPLINE to order a free replacement decal (see the back cover of this manual).
-
Page 4: Before You Begin
The model number of the treadmill is 831.297140. The serial number can be found on a decal attached to the treadmill (see the front cover of this manual for the location). -
Page 5: Assembly
ASSEMBLY Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Refer to the drawings below to identify the parts used in assembly. Assembly requires the following tools: The included allen wrench phillips screwdriver Handrail Bolt (15)–2... - Page 6 Adhesive Clip onto the Upright Base (14) in the indi- cated location. Press the Allen Wrench (73) into the Adhesive Clip. To protect the floor or carpet, place the Treadmill Mat (92) under the treadmill. 7. Make sure that all parts are tightened before you use...
-
Page 7: Operation And Adjustment
OPERATION AND ADJUSTMENT THE PERFORMANT LUBE WALKING BELT Your treadmill features a walking belt coated with PERFORMANT LUBE , a high-performance lubricant. IMPORTANT: Never apply silicone spray or other substances to the walking belt or the walking plat- form. Such substances will deteriorate the walking belt and cause excessive wear. - Page 8 (See HOW TO PLUG IN THE POWER CORD on page 7.) Battery Next, step onto the foot rails of the treadmill. Find the Cover clip attached to the key (see the drawing above), and slide the clip onto the waistband of your clothing.
- Page 9 10%. Raise the back end until it clicks into position. (Note: It may be necessary to shake the treadmill lightly so that it clicks into position.) The in- cline will then be about 5%. Raise the back end again until it clicks into position.
-
Page 10: How To Fold And Move The Treadmill
1. Hold the upper ends of the handrails. Place one foot on the base as shown. 2. Tilt the treadmill back until it rolls freely on the front wheels. Carefully move the treadmill to the desired loca- tion. Never move the treadmill without tipping it back, or the base pads may come off. - Page 11 HOW TO LOWER THE TREADMILL FOR USE 1. Hold the upper end of the treadmill with your right hand as shown. Using your left thumb, press the storage latch and hold it. Pivot the treadmill until the frame and foot rail are past the storage latch.
-
Page 12: Trouble-Shooting
2. SYMPTOM: THE POWER TURNS OFF DURING USE a. Check the circuit breaker located on the treadmill frame near the power cord (see 1. c. above). If the circuit breaker has tripped, wait for five minutes and then press the switch back in. - Page 13 Repeat until the walking belt is properly tightened. 6. SYMPTOM: THE INCLINE SYSTEM STICKS a. Raise the treadmill to the storage position. See HOW TO FOLD THE TREADMILL FOR STORAGE on page 10. Pivot the incline leg several times to break in the incline system.
-
Page 14: Conditioning Guidelines
If your goal is to burn fat, adjust the speed and incline of the treadmill until your heart rate is near one of the lower two numbers in your training zone. - Page 15 Training Zone Exercise After warming up, increase the intensity of your exer- cise until your pulse is in your training zone for 20 to 60 minutes. (During the first few weeks of your exer- cise program, do not keep your pulse in your training zone for longer than 20 minutes.) Breathe regularly and deeply as you exercise—never hold your breath.
- Page 16 PART LIST—Model No. 831.297140 Key No. Qty. Description Key/Clip Handrail Cage Nut Ratchet Screw Rear Isolator Screw Console Base Speed Control Knob Speed Potentiometer Battery Cover 7 1/2” Cable Tie Console Assembly Storage Latch Base Screw/Latch Screw Upright Base Handrail Bolt...
-
Page 18: Replacement Parts
SEARS TREADMILL EXERCISER, contact the nearest SEARS Service Center throughout the United States and SEARS will repair or replace the TREADMILL EXERCISER, free of charge. This warranty does not apply when the TREADMILL EXERCISER is used commercially or for rental pur- poses.