Fan Interface Connector
The system board has five 3-pin, shrouded, and keyed fan connectors. Two are located
next to the processor sockets (one for each processor) for a tachometer fan heat sink.
Note:
Note:
simultaneously. If you plug fans into both connectors, the fans will
not operate properly.
Pin
Signal
1
GND
2
+12V
3
Fan Sensor
Hard Drive LED Connector
Pin
Signal
1
Current limited +5 VDC
2
Key
3
HD activity LED
4
Current limited +5 VDC
External Wake ON LAN Connector
Pin
Signal
1
+5VSTNDBY
2
Ground
3
Control line from NIC
Chassis Intrusion Switch Connector
Pin
Signal
1
CHASSIS_INTRUSION_FP
2
Ground
Heatsink fans are not used with some processors.
Fan connectors 2A and 2B can not be used
Fan Connector Pinout
Hard Drive LED Connector Pinout
External Wake ON LAN Connector Pinout
Chassis Intrusion Switch Connector Pinout
Connectors E-5