Setting The Line Voltage - NEC NEAX Express Service & Reference Manual

Setting the Line Voltage

The system contains an ATX300 watt power supply that is switch-selectable for
115 or 230 VAC at an operating frequency of 50/60Hz. The power supply
voltage selection switch is factory set to 115Vac for systems shipped to North
America; it is set to 230Vac for systems shipped in Europe. Line source voltages
between 200 and 240 VAC are acceptable when the power supply input voltage
is set to 230 VAC.
Before you plug the system power cord into an AC outlet,
ensure the input line voltage setting for the power supply is
correct.
To use the system with line source voltages between 200
and 240 VAC, the line voltage selector switch on the power
supply must be set to 230. If you set the switch to the 115
VAC position, the power supply will be damaged when you
plug in your system.
When two power supplies are installed in the system both
power supplies must have their line voltage selector switch
set to the same voltage.
If you need to change the line voltage setting, perform the following steps.
Note:
the power cord will not be connected to the rear panel of
your system.
1. Unplug the AC power cord from the back of the chassis.
2. Insert the tip of a small screwdriver or ballpoint pen into the depression on
the line voltage selector.
3. Slide the selector switch to the left for 115 VAC or to the right for 230 VAC
(line source voltage range: 220 to 240 VAC).
! CAUTION
If you are setting up your system for the first time,
Setting Up the System 2-11