Arming The System - Paradox Esprit 616LED User Manual

Each access code is made up of 4 or 6 digits (pro-
grammed by your installer). The master code
474747
and user codes are identified by a 2 digit
"code number".
CODE CODE # CODE CODE #
Master 00 User 17 17
User 1 01 User 18 18
User 2 02 User 19 19
User 3 03 User 20 20
User 4 04 User 21 21
User 5 05 User 22 22
User 6 06 User 23 23
User 7 07 User 24 24
User 8 08 User 25 25
User 9 09 User 26 26
User 10 10 User 27 27
User 11 11 User 28 28
User 12 12 User 29 29
User 13 13 User 30 30
User 14 14 User 31 31
User 15 15 User 32 32
User 16 16 User 33 33
Creating User Codes:
1) Press [ ] + your master code
ENTER
user 1 code. You will hear the "
and the [ ] key will flash, to show you that the
ENTER
panel is ready to accept your code number entries.
2) Enter the two digit "code number" (01-16, or 01-48)
for the user code you wish to program (or 00 to
change the master code). You will hear the "
" beep, and the [
FIRMATION ENTER
6
UM616-626
3) Key in 4 (or 6) digits of the user code number and
press [
heard again. The [
six) digit user code has been entered into memory.
You may continue programming other user codes,
CODE CODE #
or press [
User 34 34
User 35 35
Note: [2
User 36 36
programmed).
User 37 37
User 38 38
Duress code: (applicable for software version 3.10)
User 39 39
The last user code (user 48) can be programmed to
User 40 40
report a "duress code". If you are forced to arm or
User 41 41
disarm your system under threat, a duress code can
User 42 42
be entered in the key sequence to produce a silent
User 43 43
User 44 44 alarm at the monitoring station. Check with your
User 45 45
installer to see if this option is active on your system.
User 46 46
Deleting a user code:
User 47 47
User 48 48
Pressing [
to be erased + [2
programming mode. (Note: Do not clear master code.)

ARMING THE SYSTEM

474747
or
The Esprit can be armed in 5 different ways designed to
" beep
CONFIRMATION
cover a wide variety of security situations. We suggest
that you familiarize yourself with all 5 arming procedures
so that you can take full advantage of your system.
(1) REGULAR system arming
(used for normal, day-to-day system operation)
-
CON
The keypad's green "
] key will stay "on".
]. The " " beep will be
ENTER CONFIRMATION
] key will flash. A four (or
ENTER
] to exit programming mode.
CLEAR
] key flashes if location is empty (no code
ND
] + master code + code location (01-48)
ENTER
] key + [ ]. Press [
ND ENTER CLEAR
(without partitioning)
" light must be "on" in
READY
7
UM616-626
] to exit