Paradox Esprit 616LED User Manual page 9

Note: These features are not recommended for regu-
lar use because leaving zones open can reduce the
efficiency of system protection. (Force arming and
auto bypass away arming are ideal for use with over-
head garage doors!)
"No movement" supervision feature
Your panel can be programmed to send a report and/or
arm the system if it is not armed (full or "Stay arming")
and there is no zone activity for a preprogrammed
amount of time. This is a particularly useful feature
when supervising the elderly, individuals with chronic
health problems or an individual that lives alone.
Automatically Arm on Time
Your installer can program your system to arm at a
specific time each day. In this mode, all protected
zones and detection devices must be in the "normal"
state before arming can occur.
Panic zones
If you need to signal a "panic" situation, the Esprit
provides three "panic" zones on your keypad. These
panic zones must be programmed by your installer.
Pressing keys [1] and [3] simultaneously for 2 sec.
will generate a "panic 1" or, if programmed, a "panic
alarm". Pressing keys [4] and [6] simultaneously for
2 sec. will generate a "panic 2" or, if programmed, a
"auxiliary alarm". Pressing keys [7] and [9] simulta-
neously for 2 sec. will generate a "panic 3" or, if pro-
grammed, a "fire alarm".
14
UM616-626
Based on your needs, your installer can program
these panic zones to generate audible alarms (sirens
or bells) or silent alarms, both of which also can be
sent directly to your central security station. The 3 dif-
ferent panic zones can also communicate specific
messages to your monitoring station, i.e. pressing
"panic 1" means "call the police", pressing "panic 2"
means "call an ambulance", pressing "panic 3"
means "call the fire department". Ask your installer
for the exact definition of your panel's panic alarms.
DISARMING THE SYSTEM (without partitioning)
Enter the area using the designated entry-exit
door(s). The keypad sounder emits a constant tone
to remind you to disarm your system. Enter your user
code on the keypad before the entry time expires. If
you make a mistake while entering this code, press
[ ] and re-enter it. The "
CLEAR
and the sounder will stop.
SYSTEM ARMING/DISARMING (with partitioning)
Zones can be divided into two systems. Based on
your requirements, the installer designates which
zones belong to "System A" or "System B", both sys-
À À
tems (dual area) , or are not given a system assign-
ment (common area). A zone belonging to a "dual
area" is armed if either "System A" or "System B" is
armed, and disarmed only when both systems are
disarmed.
À À
Control panel software versions 2.00 and beyond.
UM616-626
" light will go off
ARMED
15