Paradox Esprit 616LED User Manual page 6

order to arm the system. This light will only illuminate
if all zones are closed. All doors and windows must
be closed, and there can be no movement in areas
monitored by motion detectors. Once the "
light is on, enter your user code. If you make a mis-
take entering your code, the keypad sounder
" / " beep will let you know. Just press
END REJECTION
[ ] and re-enter the code.
CLEAR
When you have correctly entered your user code, the
red " " light will come on, and you will hear the
ARMED
keypad " " beep. The "
CONFIRMATION
flash and the keypad will "beep" (if programmed) dur-
ing the exit delay period. (Note: The last 10 seconds
the beep will be faster.) [ ] and [
STAY
*
flash . Your installer will program exit delay duration
based on the time you require to safely exit the pro-
tected area once the system is armed.
*
On control panel models 728, 728 EXPRESS and 738
EXPRESS using software version 2.1X, keys indicated
will not flash, but will be constantly illuminated. Software
versions 2.2X onward, keys indicated do not illuminate.
(2) "STAY" arming [ ] +
STAY
(partial system arming)
"Stay" arming allows you to remain in the protected area
while "partially" arming the system. This means that you
can stay in and move around your home, or commercial
building, while certain designated zones are armed. You
might choose to have entry/exit points like doors or win-
8
UM616-626
dows protected, or the basement, or perhaps all the
zones on the perimeter of your home or establishment.
Based on your instructions, your installer programs
"
READY
the control panel to arm certain zones in "Stay arm-
ing" mode. These programmed "Stay" zones will arm
on "Stay" mode and can only be changed by your
installer. Please remember that fire zones cannot be
bypassed. (Using this convenient feature, you can
"Stay" arm the system and then leave the premises
while others remain in the protected area.)
" light will
Pressing [
READY
below) on the keypad, activates "Stay arming" com-
mand. "Stay" arming can also be activated by a key
switch - refer to "key switch/push button arming".
] keys will
AWAY
(3) "ONE KEY" arming
(One touch system arming - no code required)
K [10] regular arming
EY
When the "
ly for 2 seconds automatically "full" arms the system, if
programmed. No user code is required. This feature
can be used to allow specified individuals like service
personnel (i.e. cleaners, maintenance) to arm the sys-
[11]
CODE OR KEY
tem when leaving the protected area, without giving
them access to any other panel operations.
K [
EY STAY
Please refer to "Stay" arming section above for a full
explanation of this feature. There is no need to wait
] + (or [
STAY ACCESS CODE KEY STAY
" light is on, pressing key [10] steadi-
READY
/11] "S tay arming"
9
UM616-626
/11] - see