Key Access Programming - Paradox Esprit 616LED User Manual

KEY ACCESS PROGRAMMING

Several control panel features can be programmed
quickly on the keypad, without entering any program-
ming addresses or section numbers.
Select "one-key access" programming mode by
pressing [ ], followed by master or user code 1.
ENTER
Then press the single key (listed below) correspond-
ing to the feature you wish to activate. (Verify first
with your installer that all of the features listed below
have been programmed and activated on your con-
trol panel. Press [ ] or [
ENTER CLEAR
key
[9] "Auto arming" time program
À À
Key [9] flashes. Enter two digits (00 to 23)
for hours + 2 digits (00 to 59) for minutes.
Á Á
(Press [ ].)
ENTER
[ ] "Panel time"
MEM
À À
Key [ ] flashes. Enter two digits (00 to 23)
MEM
for hours + 2 digits (00 to 59) for minutes.
Á Á
(Press [ ].)
ENTER
[ ] Test report
BYP
If programmed by your installer, this sends a
test report code to the monitoring station.
À À
Control panel software versions 2.00 and beyond.
Á Á
Control panel software versions prior to 2.00.
26
UM616-626
[ ] Call Espload via telephone
TRBL
If programmed by your installer, this initiates
[ ] Answer Espload
AWAY
This feature initiates "modem" communication
[ ] Cancel communication attempts
STAY
] to exit.
Stops calls from/to Espload.
When communicating with Espload, it is impossible
to enter programming mode.
communication to the central monitoring sta-
tion computer using Espload software.
between your panel and a computer running
Espload software. (The ADP-1 adapter can
also be used.)
27
UM616-626