Paradox Spectra 1641 User Quick Reference Manual

ACCESS CODES
To program Access Codes:
1) Press
2) Enter your [ ]
MASTER CODE
3) Enter three-digit section
(see Table)
4) Enter new 4- or 6-digit [
CODE
to exit
5) Press
Section: Codes:
[001] System Master Code
[002] Master Code 1
[003] Master Code 2
[004] to [047] User codes 004 to 047
[048] Duress or User code 048
To delete Access Codes:
1) Repeat steps 1 to 3
2) Press
for each digit in the code
3) Press to exit
Web site: www.paradox.ca
Security Company:
PRINTED IN CANADA 02/00 1641EQ-00
ONE-TOUCH BUTTONS
Press & hold a button for 3 seconds
without entering your Access Code.
The installer must enable each One-touch Button.
To Regular Arm: Press
To Stay Arm: Press
To Force Arm:
Press
]
Press
To Bypass:

FAST EXIT

When the system is already Stay
Armed, press and hold the button for
3 seconds to start the Exit Delay.
Press & hold:
: Stay Armed after Exit Delay
: Force Armed after Exit Delay
: Regular Armed after Exit Delay
AC LIGHT
= AC power
ON
= Power failure
OFF
STATUS LIGHT
Green:
= Zones closed
ON
= Zone(s) open
OFF
= Exit Delay
FLASH
Red:
= System armed
ON
= Stay Armed
FLASH
= Alarm
FAST FLASH

ARMING AND DISARMING

To arm
when leaving:
To Regular Arm
(Arms entire Area)
*
Enter your [ ]
ACCESS CODE
?
One-touch Button, if enabled:
To Force Arm
(Arms Area without waiting for all
zones to close)
+ Enter your [ ]
ACCESS CODE
?
One-touch Button, if enabled:
To Disarm: enter your [
*
If needed, press button(s) corresponding to desired partition(s).
User's Quick
Reference Guide
Messages on the LCD
screen will guide you
through the operations
Use arrow buttons to
scroll menu or choices
1641
To arm
when staying:
To Stay Arm
(Arms Area's perimeter)
+ Enter your [
ACCESS CODE
?
One-touch Button, if enabled:
To Instant Arm
(Stay Arms Area, but if any armed zones are
breached, it will instantly cause an alarm)
*
Stay Arm + press for 3 seconds
during the exit delay.
]
ACCESS CODE
*
]