Figure 2-12. Installing Ide, Audio, And Usb Cables - Ampro ReadySystem 1U P/N 5001791A User Manual

Chapter 2
4. Connect the IDE cable to the IDE connector (J22). See Figures 2-9, 2-10, and 2-12.
♦
If you did not disconnect the IDE cable from the hard disk drive earlier, just connect the free
end of the IDE cable to the IDE connector (J22) on the ReadyBoard.
♦
If you also disconnected the IDE cable from the hard disk drive (HDD) earlier, then re-
connect it to the IDE connector on the HDD. The red strip on the cable should match with
pin-1 on the HDD and is typically located next to the jumper settings on the HDD. See
Figure 2-12.
USB2 and USB3
Cable
M3x0.5
Screws (4)
5. You may replace the top cover before restoring power to check the ReadySystem 1U operation,
or restore power to check system operation before replacing the top cover to the enclosure.
In either case, observe all safety precautions when replacing the top cover or restoring power to
the system.
6. Follow the power-on procedures outlined in Chapter 1 to restore power to the ReadySystem.
CAUTION Depending on BIOS Setup, some ReadyBoard products will power
on as soon as you connect live DC power to the system.
18
Audio In/Out
Cable

Figure 2-12. Installing IDE, Audio, and USB Cables

Users Guide
Installing ReadySystem 1U Options
IDE Cable
ReadySystem 1U