I/O Panel Description; Figure B-2. Optional Rack-Mount Hardware (Installed); Table B-1. Installed Connectors Or Controls - Ampro ReadySystem 1U P/N 5001791A User Manual

Appendix B

I/O Panel Description

Table B-1 describes the connectors or controls on the I/O panel provided with the ReadyBox 1U shown
in Figure B-3.

Table B-1. Installed Connectors or Controls

Control/Connector Description
Power Switch
DC IN
Audio:
MIC, Line In,
Line Out
USB 2 & 3
Compact Flash
Cover and Slot
ReadySystem 1U

Figure B-2. Optional Rack-Mount Hardware (Installed)

This momentary push button Power Switch controls DC power and has an
internal cable and connector. The integrator must connect the 2-wire, 5-pin
connector to the ReadyBoard at the Utility connector.
This 2-pin coaxial connector is connected to the internal DC regulator and
accepts 12 or 24 VDC, +/- 5% from an AC-to-DC converter (brick power
supply).
These two 3-pin connectors and one 2-pin connector (MIC) with respective
cable are provided with the ReadyBox 2U. The integrator must connect the
cable to the Audio In/Out connector on the ReadyBoard.
These two 4-pin connectors with the respective cable are provided with the
ReadyBox 1U. The integrator must connect the cable to the ReadyBoard USB
header.
This compact flash cover and slot (not shown) protects the compact flash card
if installed, and ensures good EMI shielding for the ReadyBox 1U.
Users Guide
System Overview
27