Connecting The Power Cables; Figure 2-9. Connector Locations (Typical Readyboard) - Ampro ReadySystem 1U P/N 5001791A User Manual

Chapter 2
10. Insert eight M30.5, 6mm screws with washers into the standoffs on the enclosure floor. See
Figure 2-8.

Connecting the Power Cables

When connecting the cables, refer to the pin-1 designations shown in Figure 2-10. Pin-1 is shown as a
black pin (round or square) at the connectors and jumpers, unless otherwise noted. If you desire more
installation information than is provided in this guide refer to the ReadyBoard model QuickStart Guide
or Reference Manual.
NOTE The connector reference designators in the text and illustrations are
based on the ReadyBoard 700 and may be different from your
respective ReadyBoard product, but the functions will be the same and
the connector locations will typically be in the same area.
1. Connect the Power Switch (two-wire) cable to the Utility connector (pins 1 & 2) on the
ReadyBoard, matching the red wire with pin-1. See Figures 2-9, 2-10 and 2-11.
The Utility connector placement differs slightly on the various ReadyBoards, but all Utility
connectors use a 5-pin header and are in the general area shown in Figure 2-10. Refer to the
respective ReadyBoard documentation for any variations, but match the red wire with pin-1.
2. Connect the Power In cable to the Power In connector (J4). See Figures 2-9, 2-10 and 2-11.
The Power In connectors are located in the same place on all boards and use a 4-pin header.
3. Connect the Power-On cable to the Power-On connector (J6) on the ReadyBoard, as shown in
Figure 2-11. See Figures 2-9 and 2-10.
The Power-On (3-pin) connector placement differs slightly on the various ReadyBoards. Refer to
the respective ReadyBoard documentation for any variations.
4. Connect the DC In cable to the +5 volt Regulator board. See Figure 2-11.
PC/104 (J13/14)
PC/104-Plus (J12)
Power On (J6)
Power In (J4)
Fan (J1)
GPIO (J2)
Serial 3 & 4 (J3)
(COM 3 & 4)
ReadySystem 1U
Infrared (J17)
Primary IDE (J22)

Figure 2-9. Connector Locations (Typical ReadyBoard)

Users Guide
Installing ReadySystem 1U Options
Floppy/Parallel (J20)
Audio In/Out (J19)
(hidden)
Ethernet 2 (J11)
Ethernet 1 (J10)
CRT (J8)
Serial 1 & Serial 2 (COM 1 & 2)
(J5A/B) (Serial 1 Lower)
Utility (J18)
(hidden)
USB 2 & 3 (J21)
PS/2 Keyboard/
Mouse (J16)
USB 0 & 1 (J15)
(USB 0 Lower)
15