Table of Contents
Advertisement
Chapter 2
5. If necessary, remove or loosen the four screws holding the two USB cables (USB 2 & USB 3) to
the enclosure I/O Panel. See Figure 2-4.
You might be able to just loosen the two USB connectors (USB 2 & USB 3) to free the
ReadyBoard from the enclosure because of the tight fit between the two USB connectors and the
tops of the Ethernet ports. If not, you will have to remove the two USB connectors (USB 2 &
USB 3) from the enclosure. See Figure 2-4.
6. If necessary, remove the two USB cables (USB 2 & USB 3) connected to the enclosure I/O Panel.
See Figure 2-4.
Loosen or remove the
USB2 and USB3 connectors.
M3x0.5
Screws (4)
Primary IDE
ReadySystem 1U
M3x0.5 Screws (6)
Figure 2-3. Removing ReadySystem Top Cover
Audio In/Out
Figure 2-4. Removing USB Connectors
Users Guide
Installing ReadySystem 1U Options
Remove Top Cover
Power Switch
Enclosure Fan
Power In
+5V Regulator
Board
Power-On
DC In
11
Advertisement
Table of Contents
