Figure B-3. I/O Panel Controls And Connectors (Front View); Table B-2. Connectors Or Control/Indicator I/O Panel Openings - Ampro ReadySystem 1U P/N 5001791A User Manual

Appendix B
Momentary
Power Switch
COM 2
COM 1
Table B-2 describes the I/O panel access openings for connector, control, or indicators provided with the
ReadyBoard SBC shown in Figure B-4.

Table B-2. Connectors or Control/Indicator I/O Panel Openings

Access Opening
Power-On LED
HDD Activity LED
Reset Switch
Keyboard/Mouse
USB 0 & 1
LAN 1 (Ethernet 1)
LAN 2 (Ethernet 2)
Video (CRT VGA)
COM 1 & COM 2
(Serial 1 & Serial 2)
Compact Flash
Socket
28
Audio Connectors
MIC LINE IN LINE OUT
CRT
COMPACT FLASH

Figure B-3. I/O Panel Controls and Connectors (Front view)

Description
This power-on indicator is provided on the ReadyBoard.
This IDE activity indicator shows when there is I/O activity for the IDE hard
drive or compact flash card and is provided on the ReadyBoard.
This reset switch is provided on the ReadyBoard. Pressing the Reset switch
supplies a ground signal on the reset line causing a hard reset.
This 6-pin single PS/2 Keyboard/Mouse connector is provided on the
ReadyBoard. It requires a dual PS/2 output cable provided in the ReadyBoard
SBC QuickStart kit.
These two 4-pin USB type A connectors are provided on the ReadyBoard.
This 8-pin (RJ45) connector is provided on the ReadyBoard.
This 8-pin or 10-pin (RJ45) connector is provided on the ReadyBoard.
This 15-pin (DB15) connector is provided on the ReadyBoard.
These two 9-pin (DB9) connectors are provided on the ReadyBoard.
The compact flash socket (not shown) is provided on the underside of the
ReadyBoard and accepts the compact flash card, if installed, through the
opening at the bottom of the I/O panel of the ReadyBox 1U.
Users Guide
USB2 and USB3
USB2 USB3
System Overview
DC IN
RESET
POWER
HDD
ReadySystem 1U