Figure 2-6. Internal Cables Shown Separated - Ampro ReadySystem 1U P/N 5001791A User Manual

Hide thumbs

Table Of Contents

Table of Contents

Chapter 2

2. Disconnect the coaxial power cable from the DC IN connector of the I/O panel.

3. Remove any of the six screws still holding the top cover to the ReadySystem. See Figure 2-3.

4. Slide the top cover to the rear and lift it up and away from the ReadySystem.

Set aside the top cover for later re-installation.

5. If you have not made the necessary changes to the ReadyBoard, including changing the

SODIMM, do so now before continuing.

Once the ReadyBoard is installed into the ReadySystem enclosure, you will not be able to access

the SODIMM socket on the ReadyBoard.

Refer to Removing the SODIMM and Installing the SODIMM procedures.

6. Move the internal cables out of the way to allow installation of the ReadyBoard. See Figure 2-6.

♦

If you did not remove the two USB cables (USB 2 & USB 3) from the enclosure to remove

the ReadyBoard, you need to do so before installing the ReadyBoard back into the enclosure.

♦

If necessary, for greater access to the internal space of the ReadySystem, disconnect any cables

between the +5 volt regulator and the internal parts of the ReadySystem. See Figures 2-4 & 2-6.

Refer also to the respective ReadyBoard QuickStart Guide for more cable removal information.

CAUTION

To prevent damage to the static sensitive components on the

ReadyBoard, ensure you follow good Electrostatic Discharge

principles. Components on the ReadyBoard are sensitive to static

electricity and can be easily damaged by improper handling. Do the

following when handling the ReadyBoard:

Always use an anti-static wrist/ankle strap and a grounding mat.

Before you handle the ReadyBoard, touch a grounded, unpainted

metal surface to discharge any static electricity.

Audio In/Out

Cable

DC In Cable to

Regulator Board

ReadySystem 1U

Power Switch Cable

to ReadyBoard

IDE Cable