Adjust The Door; Water System Preparation - Kenmore Bootom-Mount Refrigerator Use & Care Manual

@:tse
Depending on your model, your refrigerator may have two
adjustable rollers (Style 1) or two leveler foot screws (Style 2)
located at the base of the refrigerator. If your refrigerator seems
unsteady or you want the door to close more easily, use the
instructions below.
1.
2.
Remove the base grille. Grasp the grille firmly and pull it
toward you.
Raise or lower the cabinet.
Style 1 - Front leveling
Using a 3/8"hex driver, turn the roller adjustment screw(s) on
each side to raise or lower that side of the refrigerator.
NOTE: Having someone push against the top of the
refrigerator takes some weight off the adjustment screws and
rollers. This makes it easier to turn the screws. It may take
several turns of the roller adjustment screw to adjust the tilt of
the refrigerator.
• To raise, turn the roller adjustment screw to the right.
• To lower, turn the roller adjustment screw to the left.
Turn the brake foot clockwise until it is firmly against the floor
to keep the refrigerator from rolling forward when the freezer
drawer is pulled open.
A. Front roller adjustment screw
B. Brake foot
Style 2 - Leveler screw
Using a V4" hex driver, turn the leveling screw on each side to
raise or lower that side of the refrigerator.
NOTE: Having someone push against the top of the
refrigerator takes some weight off the leveling screws. This
makes it easier to turn the screws. It may take several turns of
the leveling screw to adjust the tilt of the refrigerator.
• To raise, turn the leveling screw clockwise.
• To lower, turn the leveling screw counterclockwise.
3.
A. Leveling screw
/
Open the door again to make sure that it closes as easily as
you like. If not, tilt the refrigerator slightly more to the rear by
turning both leveling screws clockwise. It may take several
more turns, and you should turn both screws the same
amount.
4. Replace the base grille.
_,_,,,_ _' @ _,,_J
Please read before using the water system.
Immediately after installation, follow the steps below to make
sure that the water system is properly flushed.
1. Turn off the ice maker by switching the ice maker control to
OFR
I I.................... A
A. ON position
B. Auger driver
2. Install the interior water filter. The interior water filter mounting
bracket is located on the left side wall of the refrigerator
compartment.
Do not use with water that is microbiologically unsafe or
of unknown quality without adequate disinfection before
or after the system. Systems certified for cyst reduction
may be used on disinfected waters that may contain
filterable cysts.
Remove the blue bypass cap and retain for later use.
Remove the water filter from its packaging. Remove the
sealing label from the end of the filter and insert it into the
filter head.
Gently rotate the filter clockwise until it stops. Then, snap
the filter cover closed.
10