Adjust The Door; Freezer Door Models; Refrigerator Use; Using The Controls - Kenmore 596.6928 series Use & Care Manual

Adi
_S_ B _'__ ....
Your refrigerator has two front adjustable rollers located at the
base of the refrigerator. If your refrigerator seems unsteady or you
want the door to close more easily, use the instructions below.
Style 1-Freezer Door Models
1. Remove the base grille. Grasp the grille firmly and pull it
toward you.
2. Remove the bracket cover. Insert the eraser end of a pencil in
the cover notch. Apply slight downward pressure to the
notched side of the cover while swinging it off.
3.
4.
Using a screwdriver or 3/8" hex driver, turn the roller adjustment
screw on each side to raise or lower that side of the
refrigerator.
NOTE: Having someone push against the top of the refrigerator
takes some weight off the adjustment screws and rollers. This
makes it easier to turn the screws It may take several turns of
the roller adjustment screw to adjust the tilt of the refrigerator.
• To raise, turn the roller adjustment screw to the right.
• To lower, turn the roller adjustment screw to the left.
Turn the brake foot clockwise until it is firmly against the floor
to keep the refrigerator from rolling forward when the freezer
door is pulled open.
5.
6.
A. Roller adjustment screw
B. Brake foot
Open the door again to make sure that it closes as easily as
you like. If not, tilt the refrigerator slightly more to the rear by
turning both roller adjustment screws to the right. It may take
several more turns, and you should turn both adjustment screws
the same amount.
Replace the bracket cover. Place the bracket cover into the
outer edge, swing the cover toward the cabinet and snap it into
place.
Z Replace the base grille.
Style 2-Freezer Drawer Models
1. Remove the base grille. Grasp the grille firmly and pull it
toward you.
2. Using
a 1/4"
hex driver, turn the leveling screw on each side to
raise or lower that side of the refrigerator.
NOTE: Having someone push against the top of the refrigerator
takes some weight off the leveling screws. This makes it easier
to turn the screws. It may take several turns of the leveling
screw to adjust the tilt of the refrigerator.
• To raise, turn the leveling screw clockwise.
• To lower, turn the leveling screw counterclockwise.
A. Leve/ing screw
/
3. Open the door again to make sure that it closes as easily as
you like. If not, tilt the refrigerator slightly more to the rear by
turning both leveling screws clockwise. It may take several
more turns, and you should turn both screws the same amount.
4. Replace the base grille.
REFRIGERATOR USE
° Sl ....... 0_ II_@L>
The temperature controls are located at the top front of the
refrigerator or freezer compartments.
IMPORTANT:
• When the power is on, the temperature display shows the
actual temperature of the compartment.
• Wait 24 hours for your refrigerator to cool completely before
adding food. If you add food before the refrigerator has
cooled completely, your food may spoil.
NOTE: Adjusting the refrigerator and freezer temperature
controls to a colder than recommended setting will not cool the
compartments any faster.
• The recommended settings should be correct for normal
household refrigerator use. The controls are set correctly when
milk or juice is as cold as you like and when ice cream is firm.
• If the temperature is too warm or too cold in the refrigerator or
freezer, first check the air vents to be sure they are not blocked
before adjusting the controls.
11