NEC N8551-29F Instruction Manual page 6

CAUTION
Plug-in the connector up to the end.
Plug-in the cable connector firmly up to the end. If you plug-in the connector
halfway, the poor contact causes the Built-In AIT Auto-Loader Unit to be
heated up and may result in a fire. If dust collects on the outlet, it may be
heated when it comes in contact with water drops and cause a fire.
Do not hold the cable when unplugging it.
Hold the connector head when plugging or unplugging the power cable and
connection cables. The cable may be damaged if it is pulled, which may cause
a fire or electric shock.
Do not short circuit the connector pins.
This may cause a fire or electric shock.
Do not mount the Built-In AIT Auto-Loader Unit on a unit other than the
specified one.
If you mount it on an unauthorized unit, a malfunction, fire and electric shock
may be caused.
Do not block the fan.
Do not block the fan on the rear of the Built-In AIT Auto-Loader Unit. The
inner temperature will rise and may cause a malfunction, fire and electric
shock.
Do not put water or foreign materials in the Built-In AIT Auto-Loader Unit.
Do not put water/other liquids or foreign materials such as pins and clips in
the Built-In AIT Auto-Loader Unit. This may cause a fire, electric shock or
failure. If such an object is inserted by mistake into the Built-In AIT Auto-
Loader Unit, immediately turn off the power and unplug the power cable from
the outlet. Leave the Built-In AIT Auto-Loader Unit as it is (do not disassem-
ble it) and contact your dealer or the NEC maintenance service company.
Do not touch the Built-In AIT Auto-Loader Unit during lightning.
If lightning is likely to occur, unplug the power cable from the outlet. If
lightning starts before you have unplugged the power cable, do not touch the
entire unit including the cables. Otherwise, a fire or electric shock may be
caused.
vi