Table of Contents
Advertisement
8
Attach the cover to the basic processing unit. Plug the power cable to the outlet.
9
Turn on the basic processing unit.
10
When the SCSI bus can be set on the side of the basic processing unit, set the following on the
driver.
• Transfer rate
• Data bus width
• DISCONNECT/RECONNECT function
For details, see the instruction manual provided with the basic processing unit.
Hint
The orientation of the Built-In AIT Auto-Loader Unit's LCD can be changed so that it fits the Built-
In AIT Auto-Loader Unit's installation orientation in the basic processing unit (see P. 24).
Check
Set the maximum transfer rates as follows according to the number of devices connected to the
bus and the SCSI cable length.
SCSI ID
Ultra Wide SCSI
Ultra Wide SCSI
Ultra Wide SCSI
Fast Wide SCSI
Wide SCSI
* When the SCSI host and all devices connected to the same bus are LVD-compatible.
10 Built-In AIT Auto-Loader Unit
Maximum transfer
rate (Mbyte/s)
40
40
40
20
10
: 40 MByte/second (max., synchronous)
: 16 bits (Ultra Wide SCSI, LCS/SE)
: Enable
Data bus
Maximum cable
width (bit)
length (m)
Single-ended
(LVD*)
16
16
1.5 (-)
16
16
16
Maximum number
of devices
(SCSI host +
number of
devices)
3 (-)
4
8
- (3)
16
3 (3)
16
6 (3)
8
Advertisement
Table of Contents
