NEC N8551-29F Instruction Manual page 26

1
Turn off the basic processing unit and pull the power cable from the outlet.
2
Remove the cover from the basic processing unit.
3
Remove the cover from the 5.25-inch device bay of the basic processing unit.
4
Remove the mounting reel of the 5.25-
inch device bay of the basic processing
unit.
5
Mount the mounting reel removed in
step 4. on the Built-In AIT Auto-Loader
Unit.
Check
• Fix the mounting reel so that the reel
end is positioned as shown below.
• Use provided four M3 screws.
8 Built-In AIT Auto-Loader Unit
Example of the mounting reel of the basic
processing unit (The mounting reel may differ
from the following illustration depending on the
type of basic processing unit you are using.)
Mounting reel
5.25-inch device front cover
Built-In AIT Auto-
Loader Unit surface
Mounting reel end