Normal Sounds; Options - Kenmore 110.4508 Owner's Manual & Installation Instructions

Handwash/Wool
Use this cycle to clean washable woolen and special care garments.
(Check label instructions to make sure that the garment is
washable.) Similar to the way garments are hand washed in a sink,
the wash action of this cycle combines periods of extra low tumbling
speeds and soaking. Low spin speeds minimize wrinkling.
Silk/Ultra Delicate
Use this cycle to clean washable silk and ultra delicate garments.
(Check label instructions to make sure that garment is washable.)
This cycle gently tumbles and drains without spinning to gently
clean garments and minimize wrinkling. Garments will contain a
higher amount of water at the end of this cycle, because ther is
no spinning action.
Extra Cycles
Select the button for the desired cycle.
CUSTOM PROGRAM
Rinse & Spin
Use this cycle to get a rinse and spin only. This cycle combines
fast-speed tumbling and extra high speed spin. If desired, you
can reduce the spin speed by selecting the speed you want from
the SPIN SPEED modifier.
Rinse & Spin is useful for
• Loads that need rinsing only.
• Adding fabric softener to a load using the fabric softener
dispenser.
Drain & Spin
Use this cycle to drain your washer or to drain and spin your
wash load. The spin speed is preset to extra high. If desired, you
can reduce the spin speed by selecting the speed you want from
the SPIN SPEED modifier.
NOTE: Loads of synthetics, delicate fabrics, handwashables, and
woolens should be drained with no spin or low spin to avoid
fabric stress.
PRESS & HOID 3 SEC.
SOAK
RINSE& SPiN
As with any new product, you will hear sounds that you are not
accustomed to. You may hear various sounds when the door is
locked or unlocked, and during the washing, rinsing, or spinning
process. Between changes in wash actions, there will be
momentary pauses. You will hear water spraying and splashing
during the wash and rinse cycles. These new sounds and pauses
are part of normal washer operation. (See "Troubleshooting.")
DRAIN & SPiN
You can change the selection anytime before START is selected.
Custom Program
Custom Program allows you to store a customized wash cycle for
future use.
To Customize a Wash Cycle:
1. Select a cycle.
2. Select the desired Options.
3. Select the desired Modifiers.
4. To save the cycle press and hold CUSTOM PROGRAM
(approximately 3 seconds) until a beep sounds and the letters
"SET" are displayed on your machine.
5. Press START.
6. To reuse this cycle at another time, select CUSTOM
PROGRAM and press START.
Soak
Use the Soak cycle to remove small spots of set-in stains on
fabrics. This cycle provides a soak time with warm or cold water
followed by drain. Extra water, a short tumbling phase for equal
distribution of the laundry, and a soaking time without drum
movement improve the removal of set stains. Drain without spin
assures gentle treatment, even for delicate articles.
Using the Soak Cycle: The Soak cycle provides a soak time with
warm or cold water followed by drain.
1. Add detergent only to the Prewash compartment of the
Dispenser Drawer.
2. Select DRAIN & SPIN or RINSE & SPIN first, then SOAK.
3. Choose the desired soak temperature.
4. Select and hold START (approximately 1 second).
You can customize your wash by adding OPTIONS to your cycle
selections. You can add or change an option after starting a cycle
anytime before the selected option begins. Not all Options are
available with all cycles.
OPTIIONS
/
• •
PREWASH
STAINTREAT
/J ••.
SAVE ENERGY
PLUS
/ @
EXTENDED SPIN
ENDof CYCLE
SIGNAL
01! / OFF
See the "Laundry Guide" section for an overview of possible
options for each Wash Cycle selection.
You can select more than one option for a cycle. Some
options cannot be added to some cycles, for example, Stain
Treat cannot be added to the Express Wash cycle.
If an option is available with a selected cycle, the light for that
option will glow when selected.
If an option is unavailable with a selected cycle, there will be a
short tone and the light for that option will not glow when
selected.
16