Table of Contents
Advertisement
Altos R520 Installation Configuration Guide
To start RAID Web Console 2 on, select applications -> System Tools ->
4.
RAID Web Console 2 Startup UI
Red Hat Enterprise Linux 4.0 Update 3 Installation (with
integrated SAS hardware RAID)
Below information describes how to manually install Red Hat Enterprise Linux
4.0 Update 3 on Altos R520 with integrated SAS hardware RAID.
Drivers Required
For Red Hat Enterprise Linux 4.0 Update 3 Installation, the following device
drivers are required.
Device
Integrated SAS
hardware RAID
Onboard Chipset
Onboard Gigabit
Ethernet
Onboard VGA
Onboard USB 2.0
Software Required
The management utility of integrated SAS hardware RAID can be found in the
EasyBUILD.
Software
RAID Web Console
2
Configuring integrated SAS hardware RAID
Please refer to the Appendix A. for the integrated SAS hardware RAID
configuration.
Installation Tips
NOTE. There is no built-in driver Integrated SAS hardware RAID in the Red Hat
Enterprise Linux 4.0 Update2. You need an external USB floppy drive to load
driver during the OS installation.
Since Red Hat Enterprise Linux 4.0 Update2 cannot recognize the
1.
integrated SAS hardware RAID, you need to make a driver diskette from
the EasyBUILD first before the installation.
Type linux dd when the prompt boot: appears at the start.
2.
Please select the sda as the Driver Disk Source.
3.
Follow the instruction to load the integrated SAS hardware RAID driver
4.
from the driver diskette.
104
Version
00.00.03.03
EasyBUILD 7.1 build 400 (or later)
N/A
OS built-in
7.0.38-NAPI
EasyBUILD 7.1 build 400 (or later)
N/A
OS built-in
N/A
OS built-in
Version
1.13-07
EasyBUILD 7.1 build 400 (or later)
EasyBUILD Version
EasyBUILD Version
Advertisement
Table of Contents
