Table of Contents
Advertisement
Hardware Requirements for R310
SATA RAID
Your system needs to have at least two SATA hard drives installed to
create a RAID array. A single hard drive is treated as JBOD and is
insufficient to create a disk array.
SATA RAID POST information
When the server boots up, POST information displays connected SATA
HDD information, array information, and SATA JBOD information.
SATA HDD information includes:
•
attached port ID
•
HDD model
•
firmware version
•
drive capacity
•
drive status
Array information includes:
•
array RAID level
•
port
•
drive models
•
drive capacities
Server BIOS settings
Your system's BIOS settings must be modified to enable SATA RAID.
Follow the steps below to change the BIOS settings and enable RAID
configuration.
1
Enter the BIOS Setup utility by pressing F2 when prompted during
system startup. See "Entering BIOS setup" on page 60 for more
information.
99
Advertisement
Table of Contents
