Table of Contents
Advertisement
Altos R520 Installation Configuration Guide
15. Press Enter again to select array to configure.
Press spacebar to select the array and press <F10> to configure the logical
16.
drive
The default RAID level for 2 disk drives is RAID1. Just select Accept to use
17.
the default setting and press <Enter> to return to the
MENU.
Press <Enter> to end the array configuration.
18.
Select YES to Save Configuration and press any key to return to the
19.
Configure menu.
Initial RAID Volume
Press <Esc> to return to the Management Menu.
20.
Select Initialize from Management menu. All logical drives should be
21.
listed under Logical Drives.
Press <Spacebar> to select drives for initialization. The selected drive will
22.
be shown in yellow.
After selecting the drives, press <F10> and select YES to start the
23.
initialization process.
When initialization is complete, press any key to continue.
24.
Press <Esc> to return to the Management Menu.
25.
Save and Exit Embedded RAID II Configuration Utility
When RAID configuration and initialization is complete, press <Esc> in the
26.
Management Menu and select YES to exit the Embedded RAID
Configuration Utility.
Press <Ctrl> + <Alt> + <Del> to reboot the server.
27.
168
ARRAY SELECTION
Advertisement
Table of Contents
