Repositioning A Point Feature - Magellan MobileMapper - GPS Software User Manual

Selecting
Update Position
- After arriving at the feature, press the LOG button. This
takes you back to the Selected screen.
- Now that you are near the feature, highlight the Edit field
and press ENTER. You are now allowed to edit each of the
feature's attributes.
- After reviewing the attributes that need to be changed,
highlight the Close field at the bottom of the screen and
press ENTER. This ends the review of this feature and dis-
plays the Map screen again.
- Follow the same 7 steps described above to revisit and
update the other features present in the job.

2. Repositioning a Point Feature

If a point feature appears to be mislocated on the Map screen,
do the following after you have arrived at the feature and the
Selected screen showing all the feature's attributes is dis-
played:
- Press MENU, select the Update Position option and press
ENTER.
If you press NAV and go back to the Map screen, you will
now see two features (one at the old position, the other at
the new position). To remove the feature's old position
from the display, just move the map cursor so that the fea-
ture is off the screen. When you move the cursor back to
the feature, only the new position will be visible.
NOTE: The Update Position function applies only to point
features. When editing the attributes of a line or area fea-
ture, the function is not accessible. If you wish to reposi-
tion a line or area feature, you should record a new feature
and then delete the old one in MobileMapper Office.
31