Magellan MAP410 Frequently Asked Questions Manual

1 Question: How many batteries does my Map 410 GPS use?
Answer: Map 410 GPS uses four AA batteries.
How long will the batteries operate for my Map 410 GPS?
2 Question:
Using four AA batteries, your Map 410 GPS will operate
Answer:
continuously for up to 12 hours.
How long will my Map 410 GPS keep memory active without a
battery?
3 Question:
The internal lithium backup battery will keep your receiver's
memory active for up to 10 years.
Answer:
How do I install the batteries in my Map 410 GPS?
4 Question:
The Map 410 GPS uses four AA alkaline batteries that are
installed from the bottom of the receiver. Use the rings to
unscrew the water seal battery caps. Insert the batteries into
the battery tubes, with the positive end first, two batteries in
each side, and screw the battery caps until securely closed.
Answer:
Although it is recommended that four AA batteries be used, in
case of an emergency the receiver will operate with only two
batteries if both are inserted into one of the battery tubes.
How do I turn on my Map 410 GPS?
5 Question:
To turn your Map 410 GPS "on", press the power/light key and
then press the enter key when prompted. If the enter key is not
pressed within 10 seconds of being prompted, the receiver will
Answer:
turn "off". Wait for the unit to scroll through the start-up
screens.
How do I turn off my Map 410 GPS?
6 Question:
To turn your Map 410 GPS "off", press and hold the same
power/light key. This will start a shutdown sequence that
counts down the seconds until the receiver actually turns
"off". To immediately turn the receiver "off", release and press
Answer:
the power/light key again. To cancel the shutdown sequence,
press any other key.
How do I initialize my MAP 410 GPS for the first time use?
7 Question:
Turn your receiver on by pressing the power/ light key and the
Answer:
enter key, when prompted. Because this is the first time you
Map 410 GPS FAQs