Turning Power On/Off - Magellan MobileMapper - GPS Software User Manual

The very first time you
use your MobileMapper
Pro, or after erasing all
the data from memory,
the Power-On proce-
dure is longer than
described here because
the unit having no posi-
tion in memory, initial-
ization is needed to
help the unit track sat-
ellites (see 1st-time
use on page 8).
Power Down Screen

Turning Power On/Off

In the Power-On procedure described below, it is assumed
that the receiver has already been used in a working session
and so position data is available from the former working ses-
sion to help MobileMapper Pro compute its position.
• To turn the unit on, press the PWR button. The Start-up
screen appears, followed by the Database Copyright
screen and the Agreement screen. After accepting the
warning information, the last navigation screen you were
viewing at the end of the last session will be displayed.
If the last navigation screen view was the Map screen, the
last zoom scale setting will be used.
• To turn the unit off, press the PWR button. The Power
Down screen is displayed.
Doing nothing will turn off the unit at the end of the
countdown sequence.
Pressing the PWR button again will turn off the unit
immediately.
Pressing ESC will cancel the Power Down sequence.
NOTE: It is important to close any open feature and any open
job BEFORE turning the power off or switching to or from an
external source of power.
If the receiver automatically shuts down due to low power
while recording a job, it is best to open a new job after replac-
ing the batteries rather than appending more data to the pre-
viously open job that was automatically closed by the receiver.
You can easily merge both jobs in MobileMapper Office after
download.
5