Setting The Screen Backlight; Setting The Units - Magellan MobileMapper - GPS Software User Manual

To prevent acciden-
tally turning the back-
light on and leaving it
on, the unit will turn
the backlight off when
no buttons have been
pressed for 4 minutes.
Pressing any button
will turn the backlight
back on in this
instance. You can
change the time delay
for the backlight using
the Light Timer option
in the Setup menu (see
page 68).
Units Screen
6

Setting the Screen Backlight

The screen backlight can be set to one of three levels (low,
high or off). At power on, the screen backlight is set to high
level. Follow the sequence below to choose another level:
- Hold down the PWR button for 2 seconds : Backlight
drops down to low level
- Hold down the PWR button again for 2 seconds: Backlight
turns off.
- Hold down the PWR button again for 2 seconds: Backlight
comes back to high-level illumination.
Using the backlight makes the screen display easier to see,
but it also requires more power. The less you use the back-
light, the longer your batteries will last.

Setting the Units

To change the units that MobileMapper Pro will use:
- Press MENU. Use the up/down arrows to highlight Setup
and press ENTER
- Use the up/down arrows to highlight Units and press
ENTER.
- Use the up/down arrows to highlight the set of units you
want and press ENTER. Press ESC to return to the last
screen viewed