Rear Panel - Sony HVR-M35U Operating Instructions Manual

Location and Function of Parts

Rear Panel

1 MONITOR jacks
2 AES/EBU OUT jacks
3 TC OUT jack
1 Video signal input/output
section (see page 20)
2 Audio signal input/output
section (see page 22)
a MONITOR jacks
MONITOR VIDEO jack: Outputs standard-
definition video signals. Connect this jack to an
input jack of an external monitor.
When you set the DISPLAY OUTPUT switch on
the front panel to ALL or S VIDEO/VIDEO, data
items such as time code, menus or alarm messages
are superimposed on the external monitor (page
25).
Notes
• When video sync signals of the EE pictures are output
from the MONITOR VIDEO jack, sync and burst are
not synchronized.
• The same signals are output from the MONITOR
VIDEO jack and VIDEO OUT jack.
• When DV input is selected, color and luminance may
be distorted in the EE mode, depending on the monitor.
• The data items superimposed on a monitor connected
to this jack are the same as the items superimposed on
the LCD monitor. You cannot make two monitors
display different data items simultaneously.
MONITOR AUDIO jack: Outputs monaural audio
signals. Set the AUDIO MONITOR SELECT
switch to select the audio channels you want to
monitor as follows.
CH-1/2: channels 1/2
MIX:
channels 1 to 4
CH-3/4: channels 3/4
16
Chapter 1 Overview
q; LANC jack
9 HD/SD SDI OUT jack
8 RESET button
7 CONTROL S jack
6
5 POWER switch
4 AC IN connector
b AES/EBU OUT jacks
Outputs digital audio signals in AES/EBU format.
Connect these jacks to input jacks of devices with an
AES/EBU interface.
c TC OUT (time code output) jack
Outputs the time code of the unit. Connect this jack to a
time code input jack on an external device such as a time
code reader or a VCR.
The unit outputs the time code depending on the
operating state as follows:
Playing: The time code on the tape is output.
Recording: Either the time code generated by the
internal time code generator or the time code input
from an external device is output.
For details, see "HVR-M35U/M35N/M35E/M35P time
codes" on page 57.
Note
If [JOG TC OUT] in the [TC/UB SET] menu has been
set to [ON], the time code is output during search mode,
but the output time code is not continuous.
d AC IN connector
Connects to an AC outlet using the supplied power cord.
Even if the unit is in the standby mode, it consumes
power. To turn the power off completely, press the "a"
(OFF) marked side of the POWER switch 5.
HDV/DV jack