Playback; Connections For Playback - Sony HVR-M35U Operating Instructions Manual

Playback

This section describes the connections and settings for
playback and functions such as playback at various
speeds, and searching for a specific scene on a recorded
tape.

Connections for Playback

Connecting the unit to a monitor without
an i.LINK jack
You can connect the unit to a video monitor/recorder
without an i.LINK jack. Connect video cables and audio
cables as shown below. For each jack, see page 16.
Monitor/recorder
Video input
AES/EBU input
Audio input
SDI cable (not supplied)
Component video cable
(not supplied)
S-video cable (not supplied)
Video cable (not supplied)
AES/EBU cable (not supplied)
Audio cable (not supplied)
SDI input
Component video input
S-video input
When you connect the unit to a monitor compatible with
SDI audio using an SDI cable, audio cable connection is
not needed. However, when you connect the unit to a
monitor incompatible with SDI audio, a separate
connection using an audio cable is needed.
Chapter 2 Playback and Recording
HVR-M35
(rear panel)
: Signal flow
37