Sony HVR-M35U Operating Instructions Manual page 57

HVR-M35U/M35N/M35E/M35P time codes
The unit has a HDV/DV jack. The time code
displayed and recorded on the tape differs as shown
below when the INPUT SELECT switch is set to HDV/
DV and when it is set to other than HDV/DV.
[HDV/DV IN INPUT SELECT
TC] menu
Playback
HDV/DV
INTERNAL
S VIDEO
VIDEO
EE
HDV/DV
EXTERNAL
S VIDEO
VIDEO
a) This includes stop, fast-forward or rewind. If the unit
cannot read the time code on the tape correctly, the counter
displays "– –:– –:– –:– –".
b) "DUB1", "DUPLICATE1", and "REC1" represent the
state of the unit when you press each of these buttons
(AUDIO DUB, DUPLICATE, or REC) in the stop mode.
c) The time code is also displayed on the time counter screen.
For details on the time counter, see page 26.
Mode
switch
Playback
Audio dubbing
Playback at various
speeds
a)
DUB1
b)
Duplicate
DUPLICATE1 b)
Recording
Recording Pause
REC1 b)
Recording
Recording Pause
REC1 b)
Duplicate
DUPLICATE1 b)
Recording
Recording Pause
REC1 b)
Recording
Recording Pause
REC1
b)
Time code/User bits displayed and recorded
Time code/user bits on the tape
Time code/user bits on the tape (when [JOG TC OUT] is set to
[ON])
(If set to [OFF], time codes/user bits are not displayed and
recorded.)
Time code/user bits of another device connected to
HDV/DV jack c)
Time code/user bits internally generated
When the input signal is HDV: User bits input via
DV jack
Time code/user bits internally generated
Time code/user bits of the other device connected to the
HDV/DV jack c)
Time code input from the other device connected to the
HDV/DV jack and user bits internally generated
When the input signal is HDV: User bits input via the
DV jack.
Time code/user bits internally generated
Chapter 3 Utilizing the Time Code
the
c)
the
HDV/
c)
HDV/
c)
57