Sony HVR-M35U Operating Instructions Manual page 64

Duplication (Generating a work tape with the same time code)
Warning messages on duplication
If an error occurs during duplication, a STOP/CAUTION number and warning message will be displayed on the LCD
monitor and the video output screen.
The following table lists these warnings and messages.
If a warning message is displayed, check this table and take the appropriate action.
STOP/
CAUTION Warning Message
No.
RECORDER:
00 INPUT SELECT is not set to
HDV/DV.
i.LINK :
01
Cable not connected.
i.LINK :
02
Check i.LINK connection.
i.LINK :
03
Check i.LINK connection.
PLAYER:
10
Recording.
PLAYER:
11
No cassette
PLAYER:
12
Cannot control.
PLAYER:
13
Cannot control.
PLAYER:
14
Cannot control.
PLAYER:
15
Cannot control.
PLAYER:
16 Cannot record due to
copyright protection.
PLAYER:
17
Error detected.
PLAYER:
18
Moisture
RECORDER:
20
No cassette inserted.
RECORDER:
21 The tape is locked
–check the tab.
RECORDER:
22
Reinsert the cassette.
RECORDER:
23
Re-attach the power source
RECORDER:
24 Moisture condensation.
Eject the cassette
RECORDER:
25 Moisture condensation.
Turn off for 1H.
RECORDER:
26 Dirty video head.
Use a cleaning cassette.
Note
When a warning message other than those above is displayed, consult your Sony dealer.
64
Chapter 4 Dubbing to Other Equipment Using the i.LINK Jack, Duplication, Audio Dubbing, and Connecting a Computer
Cause/Remedy
The INPUT SELECT switch on the recorder (the unit) is not set to HDV/DV.
t Set the INPUT SELECT switch to HDV/DV.
The i.LINK cable is not connected correctly.
t Connect the i.LINK cable correctly.
There are multiple i.LINK connections or the i.LINK connection is looped.
t You cannot connect multiple devices. Connect only one player to the unit.
The i.LINK cable has been unplugged and plugged in again.
t Check the i.LINK cable connection. Try to duplicate again.
The player is in the recording mode.
There is no cassette in the player.
The player cannot be operated.
The player rejects operations.
The player is disabled or is in a different mode than the recorder (the unit) has
requested.
The player is in an inappropriate condition.
A copyright protected signal is recorded on the cassette in the player.
t You cannot duplicate the tape with copyright protected signals overlapped.
The player has detected self-diagnostics.
Moisture condensation has occurred in the player.
t Refer to the instruction manual of the player.
There is no cassette in the recorder.
The REC/SAVE switch is set to SAVE on the cassette.
t Slide the REC/SAVE switch to REC on the cassette.
The recorder (the unit) detected self-diagnostics.
t Insert a cassette again.
The recorder (the unit) detected self-diagnostics.
t Disconnect the power cord from the recorder.
Moisture condensation has occurred while the cassette is in the recorder (the unit).
t Remove the cassette and leave the unit for more than one hour.
Moisture condensation has occurred while the cassette is not in the recorder.
t Leave the unit for more than one hour.
The recorder's (the unit) video heads are clogged.
t Clean the video heads with the supplied cleaning cassette (see page 95).