Table of Contents
Advertisement
Installing the hardware
4.1
Installation procedure
The following installation steps are described in detail in the following sections
of this chapter:
Unpacking the system unit (see
page
40).
Installing the system unit in the rack (see
in the rack" on page 41
Connecting the cables of the system unit (see
to the system unit" on page
for connecting/disconnecting cables" on page
Connecting the system unit to the mains (see
system unit to the mains" on page
4.2
Unpacking the system unit
V
CAUTION!
Make sure you observe the safety notes in the
starting on
Only unpack the system unit at the place where you want to set it up.
The system unit must always be lifted or carried by at least three people.
(For the Japanese market, please refer to " 安全上のご注意 ").
Keep the original packaging of the system unit, as you may need it for future
transport (applies only to EMEA market).
Ê Unpack all the individual parts.
Ê Check the delivery for any damage during transport.
Ê Check whether the items delivered match the details on the delivery note.
The product name and serial number of the product can be found on the type
label.
Ê If the delivery is damaged or does not match the delivery note, contact your
supplier immediately!
40
section "Unpacking the system unit" on
and configuration diagram on the order lists).
51). Please also read the
page
27.
Operating Manual
section "Installing the system unit
section "Connecting devices
56.
section "Connecting the
52).
chapter "Important notes"
section "Instructions
BX900 S1
Hide quick links:
Advertisement
Table of Contents
