Fujitsu PRIMERGY BX900 S1 Operating Manual page 72

Installation and operation
If DHCP is activated (default), the obtained network data is
Network
displayed. Otherwise you can specify the network data manually:
Management LAN Settings (1)
IPv4 settings
– IP Address is assigned by DHCP
– Assign IP Address manually:
– IP Address
– Subnet Mask
– Gateway
Management LAN Settings (2)
IPv4 settings
– Obtain DNS address from DHCP
– Assign primary and secondary Domain Servers
– DNS Server 1
– DNS Server 2
Contains details of the power supply:
Power
– PSU Redundancy (No Redundancy)
– PSU Dynamic Mode (ON)
Contains a four-digit PIN as password protection for the
PIN
ServerView local service panel
Default values:
– PIN enable (OFF)
– PIN (0000)
Check Ekeying Check: This is a function which allows you to query the
compatibility of the modules before startup, and then activate,
partially activate or deactivate the module depending on the
result. For example, you would not activate modules whose
operating voltages or power consumption are not compatible with
the system.
This test begins automatically after switch-on or after a hardware
replacement. If errors are found, you can find out more about
them via the Details button. Replace the defective hardware
component and repeat the test.
72 Operating Manual
BX900 S1