Table of Contents
Advertisement
<< SETUP MODE >>
DOUBLE FEED CHECK
DOUBLE FEED CHECK
OFF
DOUBLE FEED CHECK
OFF
DOUBLE FEED CHECK
OFF
M3099GX/GH OEM Manual
Mode Setup type
17
Setting hopper
time
18
Setting heater
control
B3.1 Setting double-feed detection
When you set the using of double-feed detection, you must set as follows.
Screen 4
1
15mm
Screen 5
1
15mm
Screen 6
1
15mm
Screen 7
Contents
Set the time from when Start Command
Timeout limits until hopper table is lowered.
Set in EEPROM whether the heater control is
on or off.
4 At Screen 2, press [Mode 1] once to go to the
DOUBLE FEED CHECK screen. (Screen 4)
5 Press [Mode 2] to see Screen 5. If "ON" is
displayed, the error will be detected when the
double-feed is occured. If "OFF" is displayed,
it wouldn't. The "ON" or "OFF" status flips
each time you press [Mode 2].
6 Press [Mode 1] to see Screen 6. This means
how to defect the double-feed as follows.
"1" is the method by comparing with the
length of the first paper.
"2" is the method by the output of
Document detection sensor in addition to
"1".
At Screen 6, press the [Mode 2] until the
number changes as you want.
7 Press [Mode 1] to see Screen 7. This means
the length to compare with the paper based
on. If you choose "1" or "2" and set "15mm",
the double-feed is detected when the scanned
paper length is 15mm longer than the first
paper.
At Screen 7, press the [Mode 2] until the
number changes as you want.
(You can choose 10, 15 or 20mm. The
default is 15mm.)
SETUP MODE
B-3
Advertisement
Table of Contents
