A2. Panel Operation; A2.1 How To Set The Endorser On (Or Off; A2.2 How To Set The Initial Number - Fujitsu C150-E049-02EN Oem Manual

A2. Panel
operation
<< SETUP MODE >>
<< SETUP MODE >>
ENDORSER INITIAL
ENDORSER
* ON
ENDORSER
* ON
A-2
By the operator panel you can set following conditions. Other
conditions such as print offset, print characters can be set by the host
machine.

A2.1 How to set the endorser ON (or OFF)

When you use the endorser, you must set the endorser ON as follows.
Screen 1
Screen 2
VALUE
0 0 0 0 1
Screen 3
NOTICE: Set the endorser ON only when you use endorser, or the
characters may be printed on every scanned document.

A2.2 How to set the initial number

Initial number is the number which the scanner starts printing or
returns after the reset of print number.
VALUE
0 0 0 0 5
Screen 4
1 While pressing the [Mode 1], turn on the
power of the scanner. Then the LCD
displays the SETUP MODE initial
screen. (Screen 1)
2 Press [Mode 1] eight times to go to the
ENDORSER INITIAL screen. (Screen 2)
Then press [Mode 2]. If "ON" is
displayed, the endorser is already on.
(Screen 3)
3 If "OFF" is displayed, press [Mode 1],
until "OFF" blinks. Then press [Mode 2]
to turn the endorser ON. (Screen 3)
If you want to set the status in EEPROM,
go to 5 . Then if you want to close the job,
go to 6 and 7 .
4 At Screen 3, press the [Mode 1] until the
digit you want to changes blinks. Then
press [Mode 2] until the digit changes as
you want. (Screen 4: In this case the
initial number is five.)
M3099GX/GH OEM Manual