A2.3 How To Set The Print Number Reset Condition; A2.4 How To Reset The Print Number Manually - Fujitsu C150-E049-02EN Oem Manual

EEPROM WRITE?
(Mode 2 Write)
Screen 5
EEPROM Writing!!
Screen 6

A2.3 How to set the print number reset condition

You can choose whether to reset or not when HOPPER EMPTY is detected.
<< SETUP MODE >>
ENDORSER RESET METHOD
Screen 7
HOP-EMPTY RESET
ON
Screen 8

A2.4 How to reset the print number manually

You can reset the print number to the initial number by operator panel as
follows.
<< SETUP MODE >>
ENDORSER RESET
Screen 9
M3099GX/GH OEM Manual
5 To set the status in EEPROM, press [Mode 1]
until * blinks. Then press [Mode 2] to change the
LCD display into Screen 5. If you want to set,
press [Mode 2]. And the LCD displays Screen 6
about three seconds.
6 If you want to return to the ENDORSER
INITIAL screen (Screen 2), press [Mode 1] and
[Mode 2] at a time.
7 If you want to return to the initial status to read,
press [STOP].
8 At Screen 1 press [Mode 1] nine times to go to the
ENDORSER RESET METHOD screen.
(Screen 7)
9 Press [Mode 2] to see Screen 8. If "ON" is
displayed, the print number will be reset when
HOPPER EMPTY is detected. If "OFF" is
displayed, it wouldn't. The "ON" or "OFF"
status flips each time you press [Mode 1]. The
status will be set in EEPROM automatically.
10 If you want to return to Screen 7 , press [Mode
2].
If you want to close the job, go to 7 .
11 At Screen 1 press [Mode 1] ten times to go to
the ENDORSER RESET screen. (Screen 9)
ENDORSER
A-3