Dell Powerconnect W-ClearPass Hardware Appliances User Manual page 186

Figure 143:
Firewall Page (Detail 2)
When you save your Firewall configuration, it appears in the Firewall page list.
Figure 144:
Firewall Page (Overview After)
Table 97:
Firewall Page
Interface Parameter
Firewall
l
Page
l
l
l
Firewall
l
Page
l
(Detail 1)
Firewall Product/Version
Page
(Detail 2)
Peer To Peer
The Peer To Peer page provides a set of widgets for specifying specific peer to peer applications or networks to be
explicitly stopped. When you select a peer to peer network, all applications that make use of that network are
stopped.
186
Description
A Firewall Check the Firewall Application is On check box to enable testing of health
l
Application data for configured firewall application(s).
is On
Check the Auto Remediation check box to enable auto remediation of firewall
l
Auto status.
Remediation
Check the User Notification check box to enable user notification of policy
l
User violation of firewall status.
Notification
Uncheck the Uncheck to allow any product check box to check whether any
l
Uncheck to firewall application (any vendor) is running on the end host.
allow any
product
Add To configure firewall application attributes for testing against health data,
l
click Add.
Trashcan
icon To remove configured firewall application attributes from the list, click the
l
trashcan icon in that row.
Configure the specific settings for which to test against health data. All of these
checks may not be available for some products. Where checks are not available,
they are shown in disabled state on the UI.
Select the firewall product - Select a vendor from the list
l
Product version is at least - Enter the version of the product.
l
Dell Networking W-ClearPass Policy Manager 6.0 | User Guide