Installing A 3.5-Inch Device - HP ProDesk 600 Maintenance And Service Manual

Installing a 3.5-inch device

1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
Remove the front bezel
a bezel blank, remove the bezel blank. See
4.
Install 6-32 guide screws in the holes on each side of the drive.
NOTE:
on page 99
When replacing a drive, transfer the four 6-32 guide screws from the old drive to the new one.
5.
Rotate the drive cage to its upright position.
(Access panel on page
(Front bezel on page
HP has supplied four extra 6-32 guide screws on top of the drive cage. Refer to
for an illustration of the extra guide screws location.
(Preparation for disassembly on page
86).
87). If you are installing a drive in a bay covered by
Bezel blanks on page 90
85).
for more information.
Drives
Drives
103