Removing A 3.5-Inch Or 2.5-Inch Hard Drive - HP ProDesk 600 Maintenance And Service Manual

5.
Slide the optical drive through the front bezel all the way into the bay so that it locks in place.
6. Connect the power cable and data cable to the rear of the optical drive.
7. Connect the opposite end of the data cable to one of the light blue SATA connectors on the system
board.
NOTE:
drive connectors.
8.
Replace the front bezel.
NOTE:
from HP. Install the bezel trim piece in the front bezel before replacing the front bezel.

Removing a 3.5-inch or 2.5-inch hard drive

NOTE:
Before you remove the old hard drive, be sure to back up the data from the old hard drive so
that you can transfer the data to the new hard drive.
1.
Prepare the computer for disassembly
2.
Remove the access panel
Refer to System board connections on page 50
An optional bezel trim piece that surrounds the front of the slim optical drive is available
(Access panel on page
for an illustration of the system board
(Preparation for disassembly on page
38)
37)
Drives
61